Precautions for the hottest daily maintenance of p

2022-10-18
  • Detail

Matters needing attention in daily maintenance of the particle packaging machine

6. Press the lifting button of the middle crossbeam. The particle packaging machine can be input by the experimenter for data storage. The single chip microcomputer uses the program to control the LCD display and keyboard on the operation panel. The fine particles such as granules and water pills, sugar, coffee, fruit treasures, tea, monosodium glutamate, salt, desiccant, seeds and so on are packaged, and the metering, bag making, filling, and Sealing, printing batch number, blocking and counting. The working procedure is relatively complex, and if the maintenance is not timely, it is easy to avoid understanding the necessary problems according to various industry reports, so daily maintenance is very important. The following points to pay attention to:

1. The particle packaging machine needs to check the parts on schedule, once a month, to check whether the worm gear, worm, bolts on the lubrication block, bearings and other flow departments roll flexibly and wear, and if any defects are found, they should be repaired in time, It shall not be used wrongly

2. The machine should be placed in a dry and clean room for use. It is not allowed to contain acids and other corrosive gases in the atmosphere. It should be checked regularly according to the technical requirements to see whether various technical parameters are used in a smooth place with normal body

3. After the use or rest of the particle packaging machine, take out the rotating drum to clean and brush the remaining powder in the bucket, and then install it properly to prepare for the next use

4. When the drum moves back and forth during operation, please adjust the M10 screw on the front bearing pawl to the appropriate position. If the gear shaft moves, please adjust the M10 screw behind the bearing frame to the appropriate position, adjust the clearance so that the bearing does not make a sound, turn the pulley by hand, and the tightness is appropriate. If it is too tight or too loose, the machine may be damaged

5. If the machine is out of service for a long time, the whole body of the machine must be wiped and cleaned, and the smooth surface of the machine should be coated with antirust oil and covered with a cloth canopy

Copyright © 2011 JIN SHI